2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-19
• The subcode varies according to the area where the density is adjusted. Refer to the table below
and set the subcode for the area to be adjusted.
Caution after the adjustment
The adjustment may possibly cause offset failure, particularly when the highly colored original is copied
in the Photo mode. Therefore, carefully perform the adjustment, while checking the copy image.
Remarks
Enter a value within the recommended value range mentioned in the procedures. Otherwise, it may
cause a loss in MFP performance, including degradation in the image quality and a reduction in the life of
the consumables.
Subcode Area where the density is adjusted
0 Low density area
1 Middle density area
2 High density area
To Next Page
Loading...
