2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-21
(2) Perform color balance adjustment or RGB adjustment to adjust the tint of colors in general.
• For further information regarding the adjustment procedures, refer to procedure (3) in "2.3 To
Closely Match the Color Balance of the Original".
Fine adjustment cannot be made from the control panel. Therefore, in order to apply further fine
image quality adjustment, perform step (3).
(3) Select [05 ADJUSTMENT MODE] and arrange the color balance by changing the setting values for
the codes from [7960] to [7987] to adjust the density for each color.
• Set the value in increments of approximately 10, while checking the copy image until the optimum
value is obtained.
• The value for the code corresponding to the original mode (Text/Photo, Text, or Printed Image) will
affect the copy image quality in the Full color mode and the Auto Color mode.
• The setting value “25” corresponds to one step in the adjustment on the control panel.
• The subcode varies according to the area where the density is adjusted. Refer to the table below
and set the subcode for the area to be adjusted.
Color to adjust Original mode [05] code Subcode
Recommended
value
Acceptable
value range
Default
Text/Photo
Y (Yellow) 05-7960
0 / 1 / 2
Set a value larger
than 128 to increase
the density.
Set a value smaller
than 128 to decrease
the density.
0 to 255 128
M (Magenta) 05-7965
C (Cyan) 05-7970
K (Black) 05-7975
Tex t
Y (Yellow) 05-7961
M (Magenta) 05-7966
C (Cyan) 05-7971
K (Black) 05-7976
Printed Image
Y (Yellow) 05-7962
M (Magenta) 05-7967
C (Cyan) 05-7972
K (Black) 05-7977
Photo
Y (Yellow) 05-7963
M (Magenta) 05-7968
C (Cyan) 05-7973
K (Black) 05-7978
Map
Y (Yellow) 05-7964
M (Magenta) 05-7969
C (Cyan) 05-7974
K (Black) 05-7979
User Custom
Y (Yellow) 05-7980
M (Magenta) 05-7981
C (Cyan) 05-7982
K (Black) 05-7983
Red Seal Color
Y (Yellow) 05-7984
M (Magenta) 05-7985
C (Cyan) 05-7986
K (Black) 05-7987
Subcode Area where the density is adjusted
0 Low density area
1 Middle density area
2 High density area
To Next Page
Loading...
