e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
PREVENTIVE MAINTENANCE (PM)
5 - 8
Notes:
• “—” is always displayed at the drive counts section for the reversing automatic document
feeder (RADF) and feed unit.
• The paper source differs depending on the structure of options, however, “0.0k” is displayed
in “OUTPUT PAGES (k)” and its standard number of output pages is displayed in “PM
OUTPUT PAGES (k)” even for the installed paper source.
2. Sub screen
Fig. 5-4
Displaying of the sub unit (parts) name
Back to the main screen
Clearing of the chosen sub unit (parts) counters
Displaying of the present number of output pages counts (x 1,000)
“*” is displayed next to the present number when the number of output pages counts has
exceeded its PM standard number.
Displaying of the standard number of output pages counts (x 1,000) to replace the sub unit
(parts)
Displaying of the present drive counts (x 1,000)
“*” is displayed next to the present number when the number of drive counts has exceeded its
PM standard number.
Displaying of the standard number of drive counts (x 1,000) to replace the sub unit (parts)
Displaying of the number of output pages counts, drive counts and previous replacement date
for a chosen sub unit
8
1
2 3
4
5
6
7
1
2
3
4
5
6
7
8
To Next Page
Loading...
