e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
POWER SUPPLY UNIT
9 - 6
9.4 Fuse
When the power supply secondary fuse is blown out, confirm that there is no abnormality with each part
using the following table.
Voltage Board/Unit Part Fuse type
+24VD1 LGC Process unit fan F201:8A (Time-lag)
Toner motor
Polygonal motor
Upper Tray-up motor
Lower Tray-up motor
TRU fan
Switching regulator cooling fan
Auto-toner sensor
Upper drawer feed clutch
Lower drawer feed clutch
Registration roller clutch
High speed transport clutch
Low speed transport clutch
ADU clutch
Discharge LED
Main switch
High-voltage transformer
Bypass feed clutch
SLG Scan motor
Exposure lamp (lamp Inverter board)
Key copy counter / Coin controller
Bridge unit / Job separator / Offset tray
PFP/LCF
+24VD2 MOT/MOT2 ADU motor F202:8A (Time-lag)
Exit motor
Reverse motor (e-STUDIO355/455 only)
REV gate solenoid (e-STUDIO355/455 only)
Main motor
+24VD3 RADF F203:4A (Time-lag)
+24VD4 Finisher F204:5A (Time-lag)
To Next Page
Loading...
