Toshiba e-STUDIO255 - Output Channel

e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
POWER SUPPLY UNIT
9 - 4
9.3 Output Channel
The followings are two output channels which are not linked with the door switch.
1. +5V
+5VS : CN418 Pins 11 and 12
Output to the SYS board
+5VA : CN418 Pins 8 and 9
Output to the SYS board
+5VB : CN418 Pins 1
Output to the SYS board
+5VB : CN415 Pin 4
Output to the FUS board
+5VB : CN415 Pins 1, 2 and 3
Output to the LGC board, PFP/ LCF (via LGC board),
Bridge unit / Job separator / Offset tray (via LGC board)
+5VB : CN415 Pin 5
Output to the finisher
+5VB : CN419 Pins 1 and 2
Output to the SLG board
+5VB : CN419 Pin 4
Output to the RADF
2. +12V
+12VA : CN418 Pin 5
Output to the SYS board
+12VB : CN419 Pin 5
Output to the SLG board
The followings are two output channels which are linked with the door switch.
1. +5V
+5VD : CN415 Pin 14
Output to the LGC board
2. +24V
+24VD1 : CN415 Pins 19, 21, 22 and 24
Output to the LGC board, High-voltage transformer (via LGC board),
PFP/LCF (via LGC board), Bridge unit / Job separator / Offset tray (via LGC board)
+24VD1 : CN419 Pins 11 and 12
Output to the SLG board
+24VD2 : CN417 Pins 1 and 2
Output to the MOT/MOT2 board
+24VD2 : CN417 Pins 3 and 4
Output to the main motor
+24VD3 : CN419 Pins 15 and 16
Output to the RADF
+24VD4 : CN415 Pin 23
Output to the finisher