8
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
FIRMWARE UPDATING
8 - 35
8.3.5 Finisher firmware (MJ-1024)
Important:
• Be sure to shut down the equipment before installing and removing the download jig.
• Do not shut down the equipment during the update. The data could be damaged and not be
operated properly.
[A] Update Proced
Finisher firmware and saddle stitcher firmware are written on the finisher ROM. These two kinds of
firmware can be updated individually by installing the download jig to the finisher control PC board.
(1) Install the ROM to the download jig.
Make sure the direction is correct.
(2) Press the [ON/OFF] button on the control panel to shut down the equipment and turn the power
OFF using the main power switch.
(3) Take off the finisher rear cover.
Fig. 8-34
* Connect the finisher interface cable with the equipment after removing the finisher rear cover.
(4) Connect the download jig with the jig connector on the finisher control PC board.
Fig. 8-35
Finisher rear cover
Connector
To Next Page
Loading...
