e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
8 - 36
(5) Change the setting of the DIP switch on the finisher control PC board.
Change the setting of the DIP switch as follows according to the firmware to be updated.
Note:
Record the current settings of the DIP switch before changing them. After the updating is
completed, return the DIP switch to the status as record.
Fig. 8-36
<Updating Finisher Firmware>
Change all the setting of the DIP switch (1-8) to OFF.
<Updating Saddle Stitcher Firmware>
Change the setting of the DIP switch 1-6 to OFF and 7-8 to ON.
(6) Turn the power ON using the main power switch while [0] button and [8] button are pressed
simultaneously.
Updating starts automatically and the LED on the download jig lights.
Important:
The processing status can be confirmed by the lighting of the LED (LED 101-103) on the finisher
control board.
Fig. 8-37
To Next Page
Loading...
