Toshiba e-STUDIO255 - Precautions and Procedures When Replacing SRAM Board

e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
REPLACEMANT OF HDD/PC BOARDS
7 - 12
7.1.7 Precautions and Procedures when replacing SRAM board
Note:
Do not replace the HDD and the SRAM board together.
Be careful not to damage the board when replacing the SRAM board.
When you replace the SRAM board while the data encryption function is enabled, readout of the
user data/information stored in the HDD becomes impossible.
When disposing of the SRAM board, perform the following procedure.
 P.7-16 "7.2.3 Precautions when disposing of the SRAM board"
A procedure for replacing the SRAM board is shown below.
Fig. 7-3
[A] Replace SRAM board
(1) Confirm that the main power switch is turned OFF.
(2) Take off the Fax Unit (GD-1250) if it is installed.
(3) Replace the SRAM board. For the details, see the following page.
Service Manual Chap.2
Start
[A] Replace SRAM board
[E] Enable HDD encryption
[B] Initialize SRAM system storage area
[C] Clear SRAM update Error flags
[F] Adjust image quality
[G] Initialize settings when FAX unit (GD-1250) is installed
[I] Reinstall options
Setting completed
[H] Set date and time
[D] Initialize SRAM board
Start
[A] Replace SRAM board
[E] Enable HDD encryption
[B] Initialize SRAM system storage area
[C] Clear SRAM update Error flags
[F] Adjust image quality
[G] Initialize settings when FAX unit (GD-1250) is installed
[I] Reinstall options
Setting completed
[H] Set date and time
[D] Initialize SRAM board