Toshiba e-STUDIO255 - Finisher Firmware (MJ-1031)

e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
8 - 44
8.3.8 Finisher firmware (MJ-1031)
Important:
• Be sure to shut down the equipment before installing and removing the download jig.
• Do not shut down the equipment during the update. The data could be damaged and not be
operated properly.
[A] Update Procedure
(1) Install the ROM to the download jig (K-PWA-DLM-320).
Make sure the direction is correct.
(2) Press the [ON/OFF] button on the control panel to shut down the equipment and turn the power
OFF using the main power switch.
(3) Take off the hanging finisher (MJ-1031) from the equipment.
Fig. 8-46
(4) Take off the rear cover.
Fig. 8-47