e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
6 - 96
[CCB0] Offset motor abnormality
[CCD0] Stack ejection motor abnormality
[CCE0] Rear end assist motor abnormality
[CCF0] Gear change motor abnormality
MJ-1031
1. Check if the connector J104 on the finisher controller PC board is disconnected from the
offset HP sensor (SR1) or the harnesses are open circuited. Correct if any.
2. Check if the connector J107 on the finisher controller PC board is disconnected from the
offset motor (M5) or the harnesses are open circuited. Correct if any.
3. Replace the offset HP sensor.
4. Replace the offset motor.
5. Replace the finisher control PC board.
MJ-1024
Is the shutter home position sensor (PI45) normal?
NO Replace the sensor.
YES
Are the wirings between the finisher controller PC board and the stack ejection motor (M32)/
shutter clutch (CL31) correct?
NO Correct the wirings.
YES
Is there any problem with the shutter mechanism?
YES Fix the shutter mechanism.
NO
1. Replace the stack ejection motor and shutter clutch.
2. Replace the finisher controller PC board.
MJ-1024
Is the rear end assist guide home position sensor (PI39) normal?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and the rear end assist motor (M39)
correct?
NO Correct the wiring.
YES
Is there any problem with the rear end assist mechanism?
YES Fix the rear end assist mechanism.
NO
1. Replace the rear end assist motor.
2. Replace the finisher controller PC board.
MJ-1024
Is the gear change home position sensor (PI49) normal?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and the gear change motor (M40)
correct?
NO Correct the wiring.
YES
To Next Page
Loading...
