Toshiba e-STUDIO255 - Page 603

8
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
FIRMWARE UPDATING
8 - 41
(4) Take off the rear cover of the equipment.
Fig. 8-41
(5) Take off the converter PC board from the logic PC board (LGC board).
Fig. 8-42
(6) Connect the 10-pin side of the harness jig for board connection to the connector (CN2) of the
converter PC board.
Fig. 8-43
CN2