Logging in
When the equipment is controlled under department or user management, copying and other functions can be
performed if you log in according to the following procedure.
Logging in
67
Department management
You can restrict users or manage copy volumes made by an individual group or department in your company using the
department codes. When the equipment is controlled under the department code, turn the power ON and enter the
code.
When the power of the equipment is turned ON, the following menu appears.
Automatic function clear:
• This function returns all settings to default without the need to press the [FUNCTION CLEAR] button on the control panel. It
works when a specied period of time has passed since the last paper exit or the last entry of any button. When department or
user management is being used, the display returns to the department code or user information input menu. When they are not
being used, the display returns to the basic menu for the copying function.
• The period is set at 45 seconds by default at the time of installation of the equipment. To change the setting, refer to the
following guide:
& MFP Management Guide (PDF): “Chapter 2: SETTING ITEMS (ADMIN)” - “GENERAL”
• When connecting to equipment with department or user management enabled using client software, you may need to log in.
For details, ask your administrator.
Key in a department code (max. 63 digits) previously registered and press [OK] on the touch panel. The menu will switch
and the equipment will be ready for use.
If the department code keyed in is incorrect, the menu does not change. Key in the correct one.
After the operation
To prevent unauthorized use of the equipment, return the display to the department code input menu by following
either of the procedures below after you nish all operations.
• Press the [ACCESS] button on the control panel.
• Press the [FUNCTION CLEAR] button on the control panel twice.
To Next Page
Loading...
Need help?
General
