- 33 -
Installing Additional Paper Feed Unit
1
2
4
5
6
3
•
Installing Additional Paper Feed Unit
Installing additional paper feed unit will increase the amount of paper you can load. You can install
a maximum of three additional drawers. One drawer can hold 580 sheets of paper at 64 g/m
2
. By
adding an extra drawers to the standard drawer and the bypass tray, you can print up to 2430 pages
continuously.
Memo
•
The additional trays are called “Drawer 2”, “Drawer 3” and “Drawer 4”.
Additional Paper Feed
Unit
Spacer Caster Unit
Paper Feed Unit: MY-1046
Spacer: GR-1160
Caster Unit: GR-1170
Screws (22)Anti-tip Foot
Cover (2)
Anti-tip Foot
Rear (2)
Anti-tip Foot
Cover (2)
Anti-tip Foot
(2)
Anti-tip Foot
Side (2)
Note
•
Up to three drawer units can be added to the equipment
without the Inner Finisher. For the equipment with the
Inner Finisher, up to two drawer units including the spacer
can be added.
•
Place the spacer under the additional drawer unit.
May cause injury!
•
To use the Additional Tray, always use the
Caster Unit, and make sure to attach the
anti-tip feet and joint parts.
1
Open the box and remove the
additional tray. Remove the
cushioning and protective materials.
2
Turn OFF the power to the machine,
and remove the power cord and
cables.
Note
•
If you leave the power ON, you may damage the
machine.
& For details about how to turn OFF the machine, see
“Turning Power OFF” (P.52)
To Next Page
Loading...
