To Next Page

To Previous Page

4.USING TEMPLATES

Using Scan Templates 101

4 USING TEMPLATES

Press [SCAN].

For the models below, press [PREVIEW] in this step and then select the scan function in order to

preview your scans at the end of the operation.

- e-STUDIO6570C Series

- e-STUDIO6550C Series

- e-STUDIO4540C Series

- e-STUDIO2550C Series (only when the hard disk is installed)

- e-STUDIO5055C Series

- e-STUDIO507 Series

- e-STUDIO857 Series

For instructions on how to do so, see the following section:

 P.62 “Previewing Scans”

If the screen below appears, place another original on the original glass and press

[SCAN] or the [START] button to continue scanning. To finish the job, press [JOB

FINISH], followed by the [FUNCTION CLEAR] button.

 The above screen is not displayed under the following conditions:

- You scan the original from the Reversing Automatic Document Feeder

without pressing

[CONTINUE] to scan additional originals.

- A scan preview is displayed.

 To cancel the operation, press [JOB CANCEL].

 To change the scan settings, press [SCAN SETTING].

 P.50 “Changing Scan Settings”

* The Reversing Automatic Document Feeder is optional for e-STUDIO4540C Series, e-STUDIO507 Series, e-STUDIO456

Series, e-STUDIO2550C Series, e-STUDIO5055C Series, e-STUDIO307LP and e-STUDIO306LP.

Toshiba e-STUDIO5055C Series Scanning Guide

Other manuals for Toshiba e-STUDIO5055C Series