Toshiba e-STUDIO557 - Page 10

8
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
8 - 9
E552 Paper transport jam
(Exit/Reverse section
or other sections)
Paper remaining on the transport path (when the
cover is closed)
P. 8-54
E570 Transport jam during duplex printing (paper not
reaching reverse sensor-1): Paper which has
passed the fuser unit transport sensor does not
reach the reverse sensor-1 during duplex printing.
P. 8-55
E580 Paper stopping at reverse section: The trailing edge
of paper does not pass the reverse sensor-1 or
reverse sensor-2 after its leading edge has reached
the reverse sensor-1 or reverse sensor-2.
P. 8-56
E590 Paper stopping at exit section: The trailing edge of
paper does not pass the exit sensor after its leading
edge has reached the exit sensor.
P. 8-56
E5A0 Paper not reaching exit sensor: The leading edge of
paper does not reach the exit sensor.
P. 8-56
E712 RADF jam Jam not reaching the original registration sensor:
The original fed from the original feeding tray does
not reach the original registration sensor.
P. 8-68
E714 Feed signal reception jam: The feed signal is
received even no original exists on the original
feeding tray.
P. 8-69
E721 Jam not reaching the original reading start sensor:
The original does not reach the original reading
start sensor after it has passed the original
registration sensor (when scanning obverse side)
or the reverse sensor (when scanning reverse
side).
P. 8-69
E722 Jam not reaching the original exit sensor (during
scanning): The original which passed the read
sensor does not reach the original exit sensor when
it is transported from the scanning section to exit
section.
P. 8-69
E724 Stop jam at the original registration sensor: The
trailing edge of the original does not pass the
original registration sensor after its leading edge
has reached this sensor.
P. 8-70
E725 Stop jam at the reading start sensor: The trailing
edge of the original does not pass the read sensor
after its leading edge has reached this sensor.
P. 8-69
E726 Transport/exit signal reception jam during ADF
standby status
P. 8-70
E727 Jam not reaching the original reading end sensor P. 8-70
E729 Original reading end sensor paper remaining jam P. 8-70
E731 Stop jam at the original exit sensor: The trailing
edge of the original does not pass the original exit
sensor after its leading edge has reached this
sensor.
P. 8-70
E744 Stop jam at the original exit/reverse sensor P. 8-71
E745 Jam not reaching the original exit/reverse sensor P. 8-71
E746 Original exit/reverse sensor paper remaining jam P. 8-71
E762 Original registration sensor paper remaining jam P. 8-71
E770 Original width detection sensor-1 paper remaining
jam
P. 8-71
E771 Original width detection sensor-2 paper remaining
jam
P. 8-71
E772 Original width detection sensor-3 paper remaining
jam
P. 8-71
E773 Original Intermediate transport sensor paper
remaining jam
P. 8-71
E774 Original reading start sensor paper remaining jam P. 8-71
Error code Classification Contents Troubleshooting