Toshiba e-STUDIO557 - 8.2.2 Service call

e-STUDIO556/656/756/856/557/657/757/857 © 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 12
8.2.2 Service call
Error code Classification Contents Troubleshooting
C130 Paper feeding
system related
service call
1st drawer tray abnormality: The tray-up motor-1 does
not run normally or the 1st drawer tray does not move
normally.
(Feeding of any other drawer than the 1st drawer is
possible.)
P. 8-88
C140 2nd drawer tray abnormality: The tray-up motor-1 does
not run normally or the 2nd drawer tray does not move
normally.
(Feeding of any other drawer than the 2nd drawer is
possible.)
P. 8-88
C150 3rd drawer tray abnormality: The tray-up motor-2 does
not run normally or the 3rd drawer tray does not move
normally.
(Feeding of any other drawer than the 3rd drawer is
possible.)
P. 8-88
C160 4th drawer tray abnormality: The tray-up motor-2 does
not run normally or the 4th drawer tray does not move
normally.
(Feeding of any other drawer than the 4th drawer is
possible.)
P. 8-88
C180 Tandem LCF tray-up motor abnormality: The Tandem
LCF tray-up motor does not run normally or the Tandem
LCF tray does not move normally.
(Feeding of any other drawer than the Tandem LCF is
possible.)
P. 8-89
C1A0 Tandem LCF end fence motor abnormality: The Tandem
LCF end fence motor does not run normally or the
Tandem LCF end fence does not move normally.
(Feeding of any other drawer than the Tandem LCF is
possible.)
P. 8-90
C1C0 Option LCF tray-up motor abnormality: The Option LCF
tray-up motor does not run normally or the Option LCF
tray does not move normally.
(Feeding of any other drawer than the Option LCF is
possible.)
P. 8-91
C260 Scanning system
related service call
Peak detection error: Lighting of the exposure lamp
(white reference) is not detected when the power is
turned ON.
P. 8-92
C261 Peak detection error: Lighting over
(Only for e-STUDIO557/657/757/857)
P. 8-92
C262 Communication error has occurred between the CCD
board and the SYS board.
(Only for e-STUDIO557/657/757/857)
P. 8-92
C270 Carriage home position sensor not turning OFF within a
specified period of time: The carriages do not shift from
their home position within a specified period of time.
P. 8-96
C280 Carriage home position sensor not turning ON within a
specified period of time: The carriages do not reach their
home position within a specified period of time.
P. 8-98
C290 Scanner fuse blowout: 24V power for the scanning
system is not supplied at the scanner warming-up after
power-ON.
P. 8-100
C360 Process related
service call
Wire cleaner drive motor abnormality: The wire cleaner
drive motor does not run normally or the charger wire
cleaner does not move normally.
P. 8-131
C370 Transfer belt cam motor abnormality: The transfer belt
cam motor does not run normally when the power is
turned ON or the copying is started.
P. 8-131