Toshiba e-STUDIO557 - Page 99

e-STUDIO556/656/756/856/557/657/757/857 © 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 98
[C280] Carriage home position sensor not going ON within a specified time
e-STUDIO556/656/756/856
Proced
ure
Check item Result Measures
Next
step
1 Is the exposure lamp lit? Yes It is lit. 2
No It is not lit. 3
2 Carriage home position
sensor
1. Check if the harness of the carriage home position sensor is
connected properly.
2. Check if the harness is scratched or open circuited.
3. Check if the carriage home position sensor are damaged or
abnormal.
4. Replace the Carriage home position sensor.
5. Replace the Carriage home position sensor harness.
SLG board 1. Check if the harness (CN16) of the carriage home position sensor is
connected properly.
2. Check if the mounted parts on the SLG board are damaged or
abnormal.
3. Replace the SLG board.
Scan motor 1. Check if the belt tension is loosened.
2. Check if the motor fixing screw is loosened.
3. Check if the carriage wire and the timing belt come off.
4. Check if the connector is connected to the motor properly.
5. Check if the harness of the motor is caught or open circuited.
6. Replace the Scan motor.
7. Replace the Scan motor harness.
3 Carriage locking Check if the carriage locking screw for packaging is attached.
Carriage home position
sensor
1. Check if the harness of the carriage home position sensor is
connected properly.
2. Check if the harness is scratched or open circuited.
3. Check if the carriage home position sensor are damaged or
abnormal.
4. Replace the Carriage home position sensor.
5. Replace the Carriage home position sensor harness.
SLG board 1. Check if the harness (CN16) of the carriage home position sensor is
connected properly.
2. Check if the mounted parts on the SLG board are damaged or
abnormal.
3. Check if 24 V on the SLG board is short-circuited.
4. Check if 24 V is supplied to the SLG board.
5. Replace the SLG board.
Scan motor 1. Check if the belt tension is loosened.
2. Check if the motor fixing screw is loosened.
3. Check if the carriage wire and the timing belt come off.
4. Check if the connector is connected to the motor properly.
5. Check if the harness of the motor is caught or open circuited.
6. Replace the Scan motor.
7. Replace the Scan motor harness.
Replace parts Remarks
Carriage home position sensor
Carriage home position sensor harness
SLG board
Scan motor