8
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
8 - 129
[CCE1] Inserter fan motor abnormality
[CDE0] Paddle motor abnormality
Is the harness between the inserter control board and inserter fan normal?
NO Replace the harness.
YES
Is the conductor pattern around Q11, Q16 and CN8 on the inserter control board short
circuited or open circuited?
NO Replace the inserter fan.
YES
Replace the inserter control board.
Is the paddle home position sensor (PI26) working normally?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and the paddle motor (M14) correct?
YES Correct the wiring.
NO
Is the paddle drive mechanism normal?
YES Fix the mechanism.
NO
Is the problem solved by replacing the paddle motor?
NO Replace the finisher controller PC board.
YES
END
To Next Page
Loading...
