8
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
8 - 15
CB10 Finisher related
service call
Feed motor abnormality: The feed motor does not run
normally or the stack feed roller does not move normally.
P. 8-113
CB20 Delivery motor abnormality: The delivery motor does not
run normally or the delivery roller does not move
normally.
P. 8-113
CB30 Tray lift motor abnormality P. 8-114
CB40 Alignment motor (rear) abnormality: The alignment motor
(rear) does not run normally or the alignment plate does
not move normally.
P. 8-114
CB50 Staple motor abnormality: The staple motor does not run
normally or the stapler does not move normally.
P. 8-115
CB60 Stapler shift motor abnormality: The stapler shift motor
does not run normally or the Staple Unit does not move
normally.
P. 8-115
CB70 Stack amount detection sensor abnormality P. 8-115
CB80 Backup RAM data abnormality:
1. Abnormality of checksum value on the finisher
controller PC board is detected when the power is
turned ON.
2. Abnormality of checksum value on the punch
controller PC board is detected when the power is
turned ON.
P. 8-116
CB90 Paper pushing plate motor abnormality: The paper
pushing plate motor does not run normally or the paper
pushing plate does not move normally.
P. 8-117
CBA0 Stitch motor (front) abnormality: The stitch motor (front)
does not run normally or the rotational cam does not
move normally.
P. 8-118
Error code Classification Contents Troubleshooting
To Next Page
Loading...
