e-STUDIO556/656/756/856
4
05/08 Mode Element
Item Subitem Code
Details
RAM Contents
t mode
adjustment
direction(scan.section
When the value increases by "1", the image shifts by
approx. 0.09 mm toward the trailing edge of the paper.
t mode
adjustment
scan.direction
When the value increases by "1", the reproduction ratio
in the secondary scanning direction (vertical to paper
feeding direction) increases by approx. 0.025%.
t mode
Scanner Scanner Distortion mode 3033 Distortion mode - - SYS Moves carriages to the adjustment position. 6 Yes
t mode
adjustment
3034 Original glass 117 68-188 SYS 0.09524 mm/step 1
t mode
adjustment
3035 RADF 133 68-188 SYS 0.09524 mm/step 1
t mode
paper alignment
3040 Front side 12 0-20 SYS
When the value increases by "1", the aligning amount
increases by approx. 0.4 mm.
t mode
paper alignment
3041 Back side 5 0-20 SYS
When the value increases by "1", the aligning amount
increases by approx. 0.4 mm.
t mode
RADF transport
speed
When the value increases by "1", the reproduction ratio
of the secondary scanning direction on original (fed
from the RADF) increases by approx. 0.1%.
t mode
deviation adjustment
When the value increases by "1", the image of original
fed from the RADF shifts toward the rear side of paper
by approx. 0.0423 mm.
t mode
adjustment
3044 Front side 50 0-100 SYS
When the value increases by "1", the copied image of
original fed from the RADF shifts toward the trailing
edge of paper by approx. 0.2 mm.
t mode
adjustment
3045 Back side 50 0-100 SYS
When the value increases by "1", the copied image of
original fed from the RADF shifts toward the trailing
edge of paper by approx. 0.2 mm.
t mode
adjustment during
scanning from RADF
(black)
When the value increases by "1", the carriage position
shifts by approx. 0.1 mm toward the exit side when
using the RADF.
To Next Page
Loading...
