8
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
8 - 83
[ 4 ] Paper jam in inserter section
[EC00] Inserter feeding delay jam
[EC10] Inserter feeding stop jam
Are the pickup roller, feed roller and separation roller tainted?
YES Clean up the rollers.
NO
Is the harness between the inserter control board and separation sensor open-circuited?
YES Replace the harness.
NO
Is the separation sensor working improperly?
YES Replace the separation sensor.
NO
Replace the inserter control board.
Are the transport roller and reverse roller tainted?
YES Clean up the rollers.
NO
Is the harness between the inserter control board and separation sensor open-circuited?
YES Replace the harness.
NO
Is the separation sensor working improperly?
YES Replace the separation sensor.
NO
Replace the inserter control board.
To Next Page
Loading...
