8
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
8 - 85
[ECA0] Paper remaining in Inserter Unit at power-ON
[ECB0] Incorrect setting of paper size for Inserter Unit
[ECC0] Inserter Unit misfeeding
[ECD0] Inserter Unit door open jam
Is there any paper remaining at the inserter transport path?
YES Remove the paper.
NO
Are the separation sensor, reverse path sensor and transport sensor working improperly?
YES Replace the sensors.
NO
Replace the inserter control board.
Is the paper size on the inserter tray consist with the size set at the copier control panel?
NO Set the same paper size as that on the tray.
YES
Is the separation sensor working improperly?
YES Replace the separation sensor.
NO
Perform the width adjustment of the inserter tray side guide.
Is the condition improved when the copier power switch is turned OFF/ON?
NO
1. Replace the copier LGC board.
2. Replace the IPC board.
3. Replace the inserter control board.
Is the problem solved by opening the inserter jam access cover?
NO
1. Check the installation state of the cover.
2. Replace the cover switch and plate spring.
To Next Page
Loading...
