8
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
8 - 87
[EB30] Ready period time-out jam
Is there paper in the equipment?
NO Replace the LGC board.
YES
Are the IPC board and LGC board properly connected to each other?
NO Connect them properly.
YES
Is the harness securely connected to the IPC board?
NO Connect the harness properly.
YES
Is any of the connector pins of the harness connecting the equipment and finisher
disconnected or any of those harnesses open circuited?
NO Connect the pin or replace the harness.
YES
1. Replace the IPC board.
2. Replace the LGC board.
3. Replace the finisher controller PC board.
To Next Page
Loading...
