Toshiba G9 - Page 67

ACE-tronics G9 ASD Installation and Operation Manual 57
Program Mode Menu Navigation
The following table lists the menu items of the Program mode and maps the flow of the menu selections.
The Parameter Numbers for the listed functions are provided where applicable.
The functions listed may be viewed, or selected and changed as mapped below or via the Direct Access
method: Program  Direct Access  Applicable Parameter Number.
Program Mode Menu Navigation
Primary Menu Sub Menu Parameter Name
Parameter
Number
STARUP WIZARD
See the section titled Startup Wizard Requirements on pg. 42 for Startup Wizard setup information.
CRANE / HOIST
CRANE / HOIST
Motion Control Motion Control F985
Speed Control
Speed Control F986
Preset Speed 1 F018
Preset Speed 2 F019
Preset Speed 3 F020
Preset Speed 4 F021
Express Stop
Express Stop Enable F493
Express Stop Deceleration Time F511
Plugging
Plugging Enable F494
Plugging Acceleration Time F514
Plugging Deceleration Time F515
Creep Control
Creep Multiplier 1 F490
Creep Multiplier 2 F491
Creep Speed Lower Limit F492
Super Creep Control
Super Creep Pulse Count F863
Super Creep Repeat Delay F864
Super Creep Speed F865
Limit-Switch Control
Upper-Limit Speed at Slow-Speed Limit-Switch UP F294
Deceleration Time at Slow-Speed Limit-Switch UP F283
Stopping Time at Stop Limit-Switch UP F284
Upper-Limit Speed at Slow-Speed Limit-Switch DOWN F293
Deceleration Time at Slow-Speed Limit-Switch DOWN F285
Stopping Time at Stop Limit-Switch DOWN F286
Limit-Switch Stopping Method F282
ro
gra
m
efesotomasyon.com -Toshiba inverter,drive,servo,plc