Index
HX7+ ASD Quick Start Guide 99
A
Abnormal Speed Settings, 52
Accel/Decel #1 – #4 Settings, 57
Accel/Decel #1 Settings, 47
Accel/Decel Settings, 57
Accel/Decel Special, 57
Adjust Accel/Decel Automatically, 42
Alarm Popups, 47
Alarms, 62
AM, 24, 56
AM terminal, 26
Analog Filter, 50
Analog In Functions, 49
Analog1, 56
Analog2, 56
ASD Overload, 64
ASD-NANOCOM, 29
Atn, 61
At-trip Recorded Parameters, 68
Autotune Error, 64
B
Base Frequency Volts, 52
Brake Fault Timer, 52
C
Carrier Frequency, 57
CC, 24
Changed from Default, 47
Changed From Default screen, 38
Changes by Installer, 33
Charge Indicator LED, 10, 20
Circuit breaker configuration, 18
Clearing a Trip, 69
CM1, 62
CM2, 62
CN3 Pinout, 30
CN7 Pinout, 31
CNU1/1A and CNU2/2A Pinout, 30
CNU2/2A Pinout, 30
Command (RS232/RS485) Menu, 40
Command Source, 43
Communication Error, 55, 64
Communication Reference Adjust, 55
Communication Setting Parameters, 54
Communication Settings, 54
Configuration and Menu Options, 39
Connecting the ASD, 20
Connection Diagram, 34
continuous splash screen, 30
Contrast (adjustment), 47
Control Board, 29
Control Power Undervoltage, 64
CPU Fault, 64
Crane/Hoist Load, 57
Cumulative Run Timer, 52
Customer Support, 2
D
Date and time setting, 47
dbOn, 61
DC Braking, 51
DC Bus Undervoltage, 64
DC Fuse Open, 64
Dead Time Compensation, 58
Default Setting Changes, 38
Default Term. Setting, 24
Direct Access, 47
Discrete Input, 24
Discrete Output, 24
Display Units, 48
Disposal, 3
Down Key, 35
Drooping Control, 54
Dynamic Braking, 51
Dynamic Braking Resistor Overcurrent, 64
Dynamic Braking Resistor Overload, 65
E
Earth Fault, 65
EEPROM Data Fault, 65
EEPROM Fault, 65
Electronic Operator Interface, 3
Emergency Off, 65
Emergency Off Setting, 51
EMG, 62
Encoder Action, 47
Encoder Loss, 65
Enter Key, 35
EOI, 3
EOI Operation, 36
EOI Setup Options, 47
Equipment Inspection, 3
Escape Key, 35
To Next Page
Loading...
