HX7+ ASD Quick Start Guide 27
FM — This output terminal produces an output current or voltage that is proportional to the output
frequency of the ASD or of the magnitude of the function assigned to this terminal. The available
assignments for this output terminal are listed in the HX7+ ASD Installation and Operation Manual.
For further information on this terminal, see F005.
FLA — One of two normally open contacts that, under user-defined conditions, connect to FLC. The
FL relay is the Fault Relay by default, but may be programmed to any of the items of the HX7+ ASD
Installation and Operation Manual. For further information on this terminal, see F132 and Figure 7.
FLB — One of two normally closed contacts that, under user-defined conditions, connect to FLC.
FLC — FLC is the common leg of a single-pole double-throw form C relay.
Note: The FLA, FLB, and FLC contacts are rated at 2A/120 VAC and 2A/30 VDC.
Figure 7. FLA, FLB, and FLC Switching Contacts Shown in the Normal Operating Condition.
Note: The relay is shown in the normal operating condition. During
a faulted condition, the relay connection is FLC-to-FLA.
To Next Page
Loading...
