RESET IPT TO DEFAULT Four Line Phones
IPT Installation Manual Feb,, 2015 1-15
RESET IPT TO DEFAULT This process resets the IPT to the default, new, ‘out of the box’ condition.
This resert to default process is only required when using a telephone that
has been configured or previously installed on another system.
The four line display phones use a different procedure than the nine line
(large) display phones.
Four Line Phones 1. Plug the IPT into a LAN or plug in a power adapter. The IPT does not
need a network connection for this initialization procedure, it only
needs power.
2. Ensure that the handset is ‘on-hook.’
3. Press Hold+3+6+9 (simultaneously).
4. Press Vol s then press Hold.
5. Press FB1, FB2, FB3, FB4.
6. Press Hold.
7. Press Hold.
8. Lift the handset then, place it back on-hook. The IPT will initialize then
start in default mode.
Nine Line Phones 1. Plug the IPT into a LAN or plug in a power adapter. The IPT does not
need a network connection for this initialization procedure, it only
needs power.
2. Ensure that the handset is ‘on-hook.’
3. Press Hold+3+6+9 (simultaneously).
4. Press the INIT softkey.
5. Press the All Data softkey.
6. Press the EXEC softkey.
7. Press the EXEC softkey.
8. The IPT will initialize then start in default mode.
To Next Page
Loading...
