P9 ASD Quick Start Guide 39
Past Trip 3 — Past trip information or None.
Past Trip 4 — Past trip information or None.
Note: An improper P9 ASD setup may cause some trips — reset the P9 ASD to the
Factory Default settings before pursuing a systemic malfunction (Program
Utilities Type Reset Reset to Factory Settings).
Direction — Displays the Direction command (forward/reverse).
Discrete Input Terminals — Displays the status (activated = reverse video) of the discrete input
terminals of the Terminal Board.
Discrete Output Terminals — Displays the status (activated = reverse video) of the discrete
output lines of the Terminal Board.
Output Frequency
— Displays the running frequency.
Main Monitor Selections
Two (2) Monitor Mode items may be selected from the Main Monitor Selections screen to be displayed
on the Frequency Command screen while the P9 ASD is running.
Note: VLP Average and Work Hours may also be selected as Main Monitor items, but
are not displayed at the Monitor screen.
The selected items, along with their real-time values, are displayed on the Frequency Command screen
while running. Not all Monitor Mode items are available for display on the Frequency Command
screen. The available items are underlined on pg. 37 and pg. 38.
Any two of the underlined items may be selected from the listing at Program Utilities Main
Monitor Selections. Select an item from the Monitor 1 listing and another item from the Monitor 2
listing to be displayed as shown in Figure 22 on pg. 28 (DC Voltage and Output Current shown).
ain Monito
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www .ctiautomation.net - Email: info@ctiautomation.net
To Next Page
Loading...
