P9 ASD Quick Start Guide 29
System Operation
Initial Setup
The Standard Startup Wizard is run from Program\Utilities\Standard Startup Wizard and is used to
assist the user with the initial configuration of the input power settings and the output signal parameters of
the ASD. The Standard Startup Wizard is comprised of the more commonly used parameters of the
ASD. The parameters of the wizard may also be viewed or changed individually via the associated Direct
Access Numbers or the Program Menu hierarchy.
Standard Startup Wizard Parameters
Startup parameter settings may be viewed or changed. Change the parameter setting and click Next. Or
click Next without making any changes to go to the next startup parameter.
See the section titled Standard Startup Wizard Parameter Requirements on pg. 30 for further information
on the Standard Startup Wizard parameters.
1. The Voltage and Frequency Rating of the Motor (F409/F014) (Must make a selection to continue, or
select Exit).
2. The Upper-Limit Frequency (F012).
3. The Lower-Limit Frequency (F013).
4. The Automatic Acceleration/Deceleration (F000) Setting.
5. The Acceleration Time (F009).
6. The Deceleration Time (F010).
7. The Volts per Hertz Setting (F015).
8. The Motor Current Rating (F406).
9. The Motor RPM (F407).
10. The Command Source (F003).
11. The Frequency Reference Source (F004).
12. The Display Unit (F701).
13. Exit >>.
Click Exit to close the Standard Startup Wizard when done.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www .ctiautomation.net - Email: info@ctiautomation.net
To Next Page
Loading...
