80 P9 ASD Quick Start Guide
Enclosure and Conduit Plate Dimensions
The P9 ASD part numbering convention is shown below.
The enclosure dimensions for the available models (typeforms) are listed in Tables 8 and 9. The conduit
plates referenced are shown in Figures 37, 38, and 39.
P9
Part Numbering Convention.
Note: The Type 1 enclosed versions of these drives meet or exceed the specification UL 50-
1995, the Standard for Heating and Cooling Equipment, and complies with the
applicable requirements for installation in a compartment handling conditioned air.
Enclosure Dimensions
Table 8. 230-Volt P9 ASD Systems.
Frame
Model Number
VT130P9U
Enclosure
Figure
Number
A
Width
(in/mm)
B
Height
(in/mm)
C
Depth
(in/mm)
Mounting Hole Dimensions
(in/mm)
Conduit
Plate
D E R1 R2
2
2010
Figure 34
5.2/132 11.2/285 6.1/155 8.7/220 4.5/114
0.098/2.5
0.217/5.5 Figure 37-A
2015
2025
3
2035
6.1/155 12.4/315
6.6/168
9.8/249 5.4/138
2055
4
2080
6.9/175 15.0/381 11.1/283 6.2/158 0.236/6.0 Figure 37-B
2110
5B
2160
9.1/231 19.3/490 7.6/193 15.2/386 8.3/210 0.118/3.0 0.276/7.0 Figure 37-D2220
2270
62330
Figure 35
11.1/283 25.9/658 13.2/335 25.0/635
8.0/203 0.188/4.8 0.375/9.5
Figure 37-E
7B
2400
14.3/363 33.1/841 15.0/381 32.3/820 Figure 38-G
2500
2600
2750
9210K
Figure 36
14.6/371 51.7/1313
17.6/447
50.2/1275 9.2/234
0.344/8.7 0.670/17
Figure 38-I
10 212K 15.7/399 53.1/1349 51.7/1313 9.9/252 Figure 38-J
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www .ctiautomation.net - Email: info@ctiautomation.net
To Next Page
Loading...
