P9 ASD Quick Start Guide 31
Volts per Hertz Setting (F015)
This function establishes the relationship between the output frequency and the output voltage of the
ASD.
Settings:
Constant Torque
Voltage Decrease Curve
Automatic Torque Boost
Sensorless Vector Control (Speed)
Sensorless Vector Control (Speed/Torque Switching)
V/f 5-Point Curve (Go to F190 to Configure the V/f 5-Point Settings)
PM Drive (Permanent Magnet)
PG Feedback Vector Control (Speed)
PG Feedback Vector Control (Speed/Torque Switching)
Motor Current Rating (F406)
This parameter allows the user to input the full load amperage (FLA) of the motor. This value is found on
the name-plate of the motor and is used by the ASD to determine the Thermal Overload Protection
setting for the motor.
Motor RPM (F407)
This parameter is used to input the (name-plated) rated speed of the motor.
Command Source (F003)
This selection allows the user to establish the source of the Run commands. Run commands are Run,
Stop, Jog, etc.
Settings:
Use Terminal Block
Use EOI Keypad
Use RS485
Use Communication Option Board
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www .ctiautomation.net - Email: info@ctiautomation.net
To Next Page
Loading...
