P9 ASD Quick Start Guide 67
Figure 31. Complete the VLP Setup.
Figure 32. Run the Motor/Pump in the Direct Mode.
VLP Setup Wizard
Back
Press [STOP]
Virtual Linear Pump Setup
Is Now Complete
Next Exit
16. Press the Stop key to complete
the VLP setup.
17. Click Exit to save settings
(Exit available at zero Hz).
18. From the Frequency
Command screen press ESC,
scroll to the VLP Control field,
and select Direct Mode if using
no feedback (if using feedback
go to Step 21. on pg. 68).
19. While in the Hand mode, and
from the Frequency Command
screen, press Run.
20. During operation, adjust
parameters
F500
and
F501
to
stabilize VLP operation if
unstable.
Press ESC
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www .ctiautomation.net - Email: info@ctiautomation.net
To Next Page
Loading...
