4 Replacement Procedures 4.8 Touch pad
2. Disconnect the touch pad cable from the connector CN3240 on the system board.
3. Remove the following screws fixing the touch pad assembly.
• M2×3C S-FLAT HEAD screw x2
4. Remove the touch pad assembly from the palm rest while releasing the adhesive
portion.
5. Disconnect the touch pad cable from the connector on the touch pad assembly.
CN3240
Touch pad assembly
Touch pad cable
M2×3C S-FLAT HEAD
Figure 4-12 Removing the touch pad
4-22 [CONFIDENTIAL] PORTEGE R200 Maintenance Manual (960-519)
To Next Page
Loading...
