4.8 Touch pad 4 Replacement Procedures
PORTEGE R200 Maintenance Manual (960-519) [CONFIDENTIAL] 4-23
Installing the touch pad
To install the touch pad, follow the steps below and refer to Figure 4-11 and 4-12.
1. Connect the touch pad cable to the connector on the touch pad assembly.
2. Install the touch pad assembly according to the guide and secure it with the
following screws.
• M2×3C S-FLAT HEAD screw x2
3. Connect the touch pad cable to the connector CN3240 on the system board.
4. Install the touch pad cover while engaging the latches.
To Next Page
Loading...
