Toshiba Portege R200 - Getting Started with Your Portégé R200; Work Environment Setup and Safety

4.25 Hinge 4 Replacement Procedures
PORTEGE R200 Maintenance Manual (960-519) [CONFIDENTIAL] 4-51
Installing the hinge
To install the hinge, follow the steps below and refer to Figure 4-33 to 4-35.
1. Install the both sides’ hinges and secure them with the following screws.
• M3×3S BIND screw x2
• M2×4B S-FLAT HEAD screw x2
2. Pass the LCD cable through the hole and set it in place.
3. Install the palm rest and secure it with the following screws (back).
• M2.5×4B FLAT HEAD screw x4
4. Install the both sides’ hinge caps and secure them with the following screws (back).
• M2×3C S-FLAT HEAD screw x2