4.27 Fluorescent Lamp 4 Replacement Procedures
PORTEGE R200 Maintenance Manual (960-519) [CONFIDENTIAL] 4-61
2. Assembling the cell with the PCB
1) Illuminate the backlight.
2) Make sure there is no scratch or dirt on the backlight. Also check the back of the
cell. Next, install the cell with the PCB to the backlight unit.
CAUTION: 1) Install by aligning the left under corner as shown below.
2) Be careful not to damage the FPC.
Figure4-44 Replacing TMD lamp(7)
Cell with PCB
To Next Page
Loading...
