4 Replacement Procedures 4.2 Battery pack
4.2 Battery pack
Removing the Battery pack
To remove the battery pack, follow the steps below and refer to Figure 4-1.
CAUTION: When handling battery packs, be careful not to short circuit the terminals.
Also do not drop, hit or apply impact, do not scratch, break, twist or bend
the battery pack.
1. Turn off the power of the computer.
2. Disconnect the AC adapter and other external devices from the computer.
3. Turn the computer face down.
4. Release the battery lock. Pull out the battery pack while sliding the battery latch
as shown in the following figure.
Figure 4-1 Removing the battery pack
Battery lock
Battery pack
Battery latch
NOTE: For environmental reasons, do not throw away a spent battery pack.
4-8 [CONFIDENTIAL] PORTÉGÉ R500 Maintenance Manual (960-634)
To Next Page
Loading...
