4 Replacement Procedures 4.5 Memory module
4.5 Memory module
Removing the Memory module
CAUTION: The power must be turned off when you remove or insert a memory module.
Inserting a memory module with the power on might damage the module or
the computer itself. Dust and stains on the connectors may cause memory
access problems.
Never press hard or bend the memory module.
To remove the memory module, make sure the computer is powered off, follow the steps
below and refer to Figure 4-4 and 4-5.
1. Loosen the following screws and remove the memory cover.
• M2×4B STEP screw ×2
Memory cover
M2×4B STEP
Figure 4-4 Removing the memory module (1)
4-12 [CONFIDENTIAL] PORTÉGÉ R500 Maintenance Manual (960-634)
To Next Page
Loading...
