4.16 ODD/SD board 4 Replacement Procedures
4.16 ODD/SD board
Removing the ODD/SD board
To remove the ODD/SD board, follow the steps below and refer to Figure 4-22 to 4-24.
1. Disconnect the FP cable carefully from the connector CN9800 on the system board.
2. Disconnect the SD cable from the connector CN9700 on the system board.
3. Stand the ODD and remove the following screws.
• M2×3C S-THIN HEAD ×2
4. Slide the SD board outside and lift up the SD board and ODD to remove. (SD cable
is fixed to the middle frame by the double-sided tape.)
M2x3C S-THIN
HEAD
FP cable
SD cable
ODD
Guide
SD board
CN9800
CN9700
Double-sided tape
Figure 4-22 Removing the ODD/SD board (1)
PORTÉGÉ R500 Maintenance Manual (960-634) [CONFIDENTIAL] 4-39
To Next Page
Loading...
