4.13 Bluetooth module 4 Replacement Procedures
4.13 Bluetooth module
Removing the Bluetooth module
To remove the Bluetooth module, follow the steps below and refer to Figure 4-16.
*The Bluetooth module is not mounted in some models.
1. Disconnect the USB cable carefully from the connector CN9610 on the USB board.
2. Disconnect the Bluetooth antenna cable and Bluetooth cable from the connector on
the Bluetooth module.
3. Remove the following screw and Bluetooth module.
• M2×3C S-THIN HEAD ×1
Bluetooth module
Bluetooth antenna cable
Bluetooth cable
USB cable
M2x3C S-THIN HEAD
CN9610
Figure 4-16 Removing the Bluetooth module
PORTÉGÉ R500 Maintenance Manual (960-634) [CONFIDENTIAL] 4-29
To Next Page
Loading...
