4.21 Touch pad/Fingerprint sensor board 4 Replacement Procedures
5. Peel off the TP cable adhered with the double-sided tape and remove the tip point of
the cable (connector terminal side) from the hole.
6. Remove the following screw securing the fingerprint sensor board.
• M2×3C S-THIN HEAD ×1
7. Remove the fingerprint sensor board adhered with the double-sided tape from the
slot.
Fingerprint sensor board
TP cable
M2x3C S-THIN HEAD
Figure 4-34 Removing the touch pad/fingerprint sensor board (2)
PORTÉGÉ R500 Maintenance Manual (960-634) [CONFIDENTIAL] 4-55
To Next Page
Loading...
