4.23 LCD unit 4 Replacement Procedures
Installing the LCD unit
To install the LCD unit, follow the steps below and refer to Figure 4-36 and 4-37.
CAUTION: When installing a new LCD cable, stick a new cushion to the LCD cable.
1. Connect the LCD cable to the connector on the LCD unit.
2. Install the LCD unit to the LCD cover and arrange the LCD cable in place.
CAUTION: Do not put the LCD cable on the LCD unit.
LCD cable
3. Place the LCD mask to the LCD unit and secure it with the following screws.
• M2×2.4C FLAT HEAD screw ×4
4. Stick three mask cushions and one mask seal on the LCD mask.
PORTÉGÉ R500 Maintenance Manual (960-634) [CONFIDENTIAL] 4-61
To Next Page
Loading...
