Tests and Diagnostics
3-48 [CONFIDENTIAL]) PORTÉGÉ R700 Series Maintenance Manual (960-833))
Subtest 02 USB
NOTE: When executing this subtest, USB test module and USB cable must be
connected.
This subtest checks if USB port works properly.
The following menu appears in the display.
#################################################################
######## USB Port Select (XXXXXXXXX) #######
#################################################################
* *
* 0 ............ Port 0 (Right side) *
* 1 ............ Port 1 (Left side) *
* *
* 9 ............ Eeit to Only One menu *
*****************************************************************
.... Press test number[0,1,9] ?
Connect the USB test module and USB cable to the computer.
Input the port test number and press Enter.
OK message appears in the display if the test ends without a defective.
NG message appears in the display if a defective is found during the test.
Confirm the connection of cable, then execute the test again.
Press 9 and return to ONLY ONE TESST menu.
To Next Page
Loading...
