4 Replacement Procedures 4.14 DC fan
4-40 [CONFIDENTIAL] PORTÉGÉ R700 Maintenance Manual (960-833)
4.14 DC fan
Removing the DC fan
To remove the DC fan, follow the steps below and refer to Figure 4-24.
1. Peel off the insulator and remove the following screws securing the DC fan.
• M2.5×4B FLAT HEAD ×2
2. Disconnect the fan harness from the connector CN3380 on the system board.
3. Remove the DC fan from the slot.
Figure 4-24 Removing the DC fan
CN3380
DC fan
M2.5x4B FLAT HEAD
Fan harness
Insulator
To Next Page
Loading...
