4 Replacement Procedures 4.26 Camera module
4-82 [CONFIDENTIAL] PORTÉGÉ R700 Maintenance Manual (960-833)
4.26 Camera module
Removing the Camera module
To remove the camera module, follow the steps below and refer to Figure 4-49.
1. Turn up the insulator and disconnect the camera harness from the connector on the
camera module.
2. Take out the camera module from the slot of the LCD cover.
NOTE: Do not reuse the removed camera module. Be sure to use a new camera module.
Figure 4-49 Removing the camera module
Camera module
Camera harness
Insulator
To Next Page
Loading...
