4.8 Base assembly 4 Replacement Procedures
PORTÉGÉ R700 Maintenance Manual (960-833) [CONFIDENTIAL] 4-25
Installing the Base assembly
To install the base assembly, follow the steps below and refer to Figure 4-11 to 4-13.
1. Set the base assembly to the cover assembly.
NOTE: Set the base assembly as shown in the figure below.
2. Secure the base assembly and cover assembly with the following screws.
Dock model
• M2.5×6B FLAT HEAD screw ×15 (Described as “6” in the Figure 4-12)
• M2.5×4B FLAT HEAD screw ×5 (Described as “4” in the Figure 4-12)
With out Dock model
• M2.5×6B FLAT HEAD screw ×13 (Described as “6” in the Figure 4-12)
• M2.5×4B FLAT HEAD screw ×5 (Described as “4” in the Figure 4-12)
• M2.5×12B FLAT HEAD screw ×2 (Described as “12” in the Figure 4-12)
3. Connect the ExpressCard FPC to the connector CN2520 on the system board and
insert the tab under the cover.
To Next Page
Loading...
