Toshiba RAS-B10SKVP-E - SPECIAL MAINTENANCE PROCEDURES; PLASMA PURE FILTER CLEANING; POST-CLEANING FILTER VERIFICATION


2211 EENN
E
E
NN
GG
LL
II
SS
HH
FF
RR
AA
NN
ÇÇ
AA
II
SS
DD
EE
UU
TT
SS
CC
HH
II
TT
AA
LL
II
AA
NN
OO
EE
SS
PP
AA
ÑÑ
OO
LL
ΕΕ
ΛΛ
ΛΛ
ΗΗ
ΝΝ
ΙΙ
ΚΚ
ΗΗ
PP
OO
RR
TT
UU
GG
UU
ÊÊ
SS
##
##
##
SS
WW
##
##
##
##
##
##RR
UU
##
##
##
Cleaning the plasma pure filterCleaning the plasma pure filter
Preparation:Preparation:
1.1. TTurn off the air condurn off the air conditioitioner usinner using the remotg the remote controe controllerller..
2.2. TTurn ourn off ff the the powpower ser supplyupply..
•• Clean the plasma Clean the plasma pure filter when pure filter when the FILthe FILTER indicator (orTER indicator (orange) turns on.ange) turns on.
(This indicator turns on after PURE (This indicator turns on after PURE operation of about 1000 hours.)operation of about 1000 hours.)
•• After cleaning is After cleaning is finished, push the finished, push the RESET buttRESET button on the indoor on on the indoor unit.unit.
•• PerPerform clform cleaning eeaning every six mvery six months or soonths or so..
•• Even if the FILEven if the FILTER indicator does not turn on, clean the plasma pure filter whenever the unit makTER indicator does not turn on, clean the plasma pure filter whenever the unit makes a humming, clicking, or buzzinges a humming, clicking, or buzzing
sound. If the indicator turns on sound. If the indicator turns on during the night, the air conditioner during the night, the air conditioner can still be used until the can still be used until the morning without a problem, but be suremorning without a problem, but be sure
to perform cleaning as soon as possible.to perform cleaning as soon as possible.
11 Open the air inlet grille.Open the air inlet grille.
Lift up the air inlet grille Lift up the air inlet grille until it clicks into place.until it clicks into place.
22 Grasp the left and right handles of the air filter and lift up slightly and then pullGrasp the left and right handles of the air filter and lift up slightly and then pull
downward to remove the filter from the downward to remove the filter from the filter holder.filter holder.
33 Take out the plasma pure filter.Take out the plasma pure filter.
•• GrasGrasp the handlp the handles, anes, and then pull od then pull out as shout as shown inwn in aaandand bb..
Checks after cleaning the plasma pure filterChecks after cleaning the plasma pure filter
1.1. ConfiConfirm the FILrm the FILTER indicTER indicator does noator does not turn on by activt turn on by activating PURating PURE operatE operation forion for
one hour or more.one hour or more.
<If it does not turn on, it is normal><If it does not turn on, it is normal>
2.2. If the If the FILFILTER inTER indicatdicator turns oor turns on, recn, recheck heck the fthe followollowing.ing.
a) Fitting of the plasma pure a) Fitting of the plasma pure filterfilter
b) Fitting of the air inlet grilleb) Fitting of the air inlet grille
And, reconfirm the FILTER indicator does not turn on by activating PURE operation for another one hour or more.And, reconfirm the FILTER indicator does not turn on by activating PURE operation for another one hour or more.
<If it does not turn on, it is normal><If it does not turn on, it is normal>
3.3. In case the FIIn case the FILLTER indicTER indicator does tator does turn on, please caurn on, please call a service repll a service representresentativative.e.
SPECIAL MAINTENANCE
SPECIAL MAINTENANCE
11
22