Toshiba RAS-B10SKVP-E - PARTS IDENTIFICATION; OUTDOOR UNIT COMPONENTS; INDOOR UNIT COMPONENTS; INDOOR UNIT CONTROLS AND INDICATORS


33 ENEN
E
E
NN
GG
LL
II
SS
HH
FF
RR
AA
NN
ÇÇAA
II
SS
DD
EE
UU
TT
SS
CC
HH
II
TT
AA
LL
II
AA
NN
OO
EE
SS
PP
AA
ÑÑ
OO
LL
ΕΕ
ΛΛ
ΛΛ
ΗΗ
ΝΝ
ΙΙ
ΚΚ
ΗΗ
PP
OO
RR
TT
UU
GG
UU
ÊÊ
SS
##
##
##
SS
WW
##
##
##
##
##
##
RR
UU
##
##
##
Outdoor unitOutdoor unit
aa Refrigerant connecting pipe and electric wiresRefrigerant connecting pipe and electric wires
bb Air inlet (Side and rear)Air inlet (Side and rear)
cc Air outletAir outlet
Indoor unitIndoor unit
dd Room temperature sensorRoom temperature sensor
ee Front panelFront panel
ff Air inlet grilleAir inlet grille
gg Air filterAir filter
hh Air outletAir outlet
ii
Horizontal air flow louverHorizontal air flow louver
Located at the back of the vertical air Located at the back of the vertical air flow louverflow louver..
jj
Vertical air flow louverVertical air flow louver
kk Display panelDisplay panel
ll Infrared signal receiverInfrared signal receiver
mm Remote controllerRemote controller
nn Plasma pure filterPlasma pure filter
Display panelDisplay panel
The operating states are The operating states are shown below.shown below.
aa RESET buttonRESET button
bb FILFILTER indicator TER indicator (Orange)(Orange)
cc TIMER indicator (Yellow)TIMER indicator (Yellow)
dd PURE indicator (Blue)PURE indicator (Blue)
ee OPERAOPERATION indicator TION indicator (Green)(Green)
The operation indicators flash rapidly (5 times per second)The operation indicators flash rapidly (5 times per second)
when a safety protection feature is when a safety protection feature is activated.activated.
ff S.CLEAN indicator (Green)S.CLEAN indicator (Green)
When the unit shuts down after having operated for 10 or moreWhen the unit shuts down after having operated for 10 or more
minutes in the cooling or drminutes in the cooling or dry mode, the cleaning operation isy mode, the cleaning operation is
started automatically, and the S.CLEAN indicator turns on.started automatically, and the S.CLEAN indicator turns on.
RESET buttonRESET button
The RESET button has The RESET button has the following two functions.the following two functions.
•• ReReseset funt functctioionn
Use when the Use when the FILFILTER indicator (orange) is TER indicator (orange) is on. (on. (see pasee pagege 20.20.))
•• TTemporemporary operary operation fation functiunctionon
Use when you misplace or lUse when you misplace or lose the remote controller, or when itsose the remote controller, or when its
batteries are used up. (batteries are used up. (see pasee pagege 18.18.))
NAMES
NAMES OF POF PARTSARTS
NAMES AND FUNCTIONS OF INDICATORS AND CONTROLSNAMES AND FUNCTIONS OF INDICATORS AND CONTROLS
ON INDOOR UNITON INDOOR UNIT
aa
bb
cc
mm
nn
gge e ff
i i h h k k l l jj
dd
a a b b c c d d e e ff