– 46 –
Item Operation fl ow and applicable data, etc. Description
18. Set temperature
correction
Indoor Control P.C. Board (Factory Default)
L01
DB01
C03
T101
IC801
J804
J805
J806
J807
Jumper wire
J804
J805
J806
J807
In HEAT Operation
1. Purpose
When the difference between the set
temp. of the remote controller and
the room temp. is wide due to the
installation condition, etc, the set temp.
is corrected.
(HEAT operation only)
2. Description
The set temp. received from the remote
controller is corrected.
The correct value from –2°C to +4°C
is changed by the jumper wire on P.C.
board of the indoor microcomputer.
k At shipment
: With Jumper wire
: Cut Jumper wire
Jumper wire setup
J804 J805
××
×
×
HEAT
shift value
–2
+4
+2
0
To Next Page
Loading...