– 56 –
Wiring
1. Remove a screw and then remove cover of the
electric parts box.
2. Strip wire ends (10 mm).
3. Match wire colors with terminal numbers on indoor
and outdoor units’ terminal blocks and firmly screw
wires to the corresponding terminals.
4. Connect the ground wires to the corresponding
terminals.
5. Fix the wires with cord clamp.
6. Fix cover of the parts box and the terminal block
surely with the fixing screws.
Make a loop on the wire for margin of the
length so that the electric parts box can be
taken out during servicing.
Connecting wire
Earth line
10
50
10
70
123
1
2
3
Indoor side
Outdoor side
Indoor/Outdoor
connecting wires
1
1
L N
2
2
3
3
NOTE
Wire type: H07RN-F or 60245IEC66 (1.0 mm²)
Wiring diagram
To Next Page
Loading...
